Operation And Use - Niko 360-45010 Mode D'emploi

360-45010
390-40011
Wiring diagram (fig.2)
- Connect the light sensor (350-10011) and motion sensor (350-20010/350-20011) to terminal
range A. You can connect several motion sensors (max. 8) in parallel. You can only connect one
light sensor per system.
- Connect the manual controls to terminal range B.
- Connect the RJ12-inputs of the Power Pack and the daylight control module via 390-40011.
Startup
The light sensor (350-10011) has to be placed and connected correctly before switching on the
mains supply. Proceed as follows:
- Switch on the mains supply.
- Confirm the sensor value on the display.
- The module is powering up.
- The module is ready for use.
If the daylight control module has already been switched on before the light sensor was placed and
connected correctly, you can repeat the initiation of the sensor (see '4.2. ADJUSTMENT>adjust settings').

3. OPERATION AND USE

3.1 Light sensor (350-10011) (fig.2)
The lighting is switched on if the sensor measured insufficient daylight.
3.2 Motion sensor (350-20010/350-20011) (fig.2)
The motion sensor(s), max. 8 in parallel, enable the lighting to be switched on in case motion is detected.
3.3 Manual control (fig.2)
Push button 170-00000
Depending on the application (see 3.4), you can connect a manual push button to switch the
lighting on and off.
Time switch 420-00200 + 1XX-78200
Depending on the application (see 3.4), you can connect a time switch in order to switch the
lighting on and off.
38 EN