IWatMotion iWatBike iRider Mode D'emploi page 40

EN
TROUBLESHOOTING
Fault
No power when the
bike is turned on.
Mileage not enough.
Battery doesn't
charge.
LCD Display not
working.
The motor does not
work when the bike is
powered On
Cause
1. No Battery.
1. Battery is not fully charged.
2. Tire pressure is low.
3. Frequent brakes/starts/
overload during use.
4. Battery is aging or is
decreasing due to use.
5. Low temperature, battery
attenuation.
1. Charger is unplugged.
2. Battery temperature too low.
3. Battery temperature too high.
1. No power.
2. Faulty Adaptor.
3. Faulty.
1. Check the condition of the
brakes.
2. Faulty.
Solution
1. Check if the battery is installed
correctly.
2. Check if battery needs charging.
1. Check that the charger is working
properly.
2. Check tire pressure before riding.
3. Ride with caution.
4. Replace battery.
5. This is normal.
1. Check if the plug is loose.
2/3. Wait until temperature goes back
to normal.
1. Check battery condition.
2/3. Contact the after-sales service for
replacement.
1. Check brake.
2. Contact the after-sales service for
replacement.
40