IWatMotion iWatBike iRider Mode D'emploi page 38

EN
BATTERY AND CHARGE
1. Charge in temperatures ranging from 0ºC~45ºC and discharge between -20ºC~60ºC. Keep the battery dry.
2. Keep the battery away from acid, alkaline, water, fire, heat and high temperature environments.
3. Do not mix-up the positive and negative ends of the power supply. Also, do not damage, disassemble or
short-circuit the battery.
4. Charging the battery with the equipped adaptor and charger, charging time must not exceed 6 hours,
charging current must not exceed 2A.
5. If the battery is not to be used in a long time, keep the battery in a dry and cool environment, and charge
it for 2 hours every two months.
6. Charge according to the manual requirements, f not we cannot take responsiblity for the damages caused.
7. Charge in a dry and cool environment, do not charge in closed or high temperature areas.
8. Unplug the charger in time when the charging is done, do not plug the charger nto a power source while
not charging.
9. Plug in the battery first, then connect to the power source to charge. After charging, disconnect the power
source first, then unplug the charger.
10. If the charger indicator stops working or the charger overheats and causes a funny smell, unplug the
charger immediately and repair or replace the charger.
11. Keep the charger away from fluids whilst in use or in storage, in case of short circuit, avoid any penetration
to the charger.
12. Try not to carry the charger around with your bike, if you must, make sure it's well protected and store it
in your tool box.
13. Avoid that the battery become fully discharged when in use.
14. Do not attempt to disassemble or replace any parts of the charger yourself.
15. Do not put the battery in places where it may fall to the ground, in case of battery leakage or over-heating
which could lead to fire or an explosion.
38