Fitting The Feeder; Fitting The Bearing Into The Telescopic Section; Fixing The Telescopic Section In The Drum - Facnor EC39 Notice De Montage

4.6- FITTING THE FEEDER

4.7- FITTING THE BEARING INTO THE TELESCOPIC SECTION

top
Give the
bearing a
quarter turn
Assemble one bearing beneath the telescopic section, the male side pointing up. Fit the
bearing to the telescopic section and give it a quarter turn.
IMPORTANT: Doing this ensures that the bearing is fixed in place at the bottom
of the telescopic section (fig. L).

4.8- FIXING THE TELESCOPIC SECTION IN THE DRUM

Fasten another halyard to the tack shackle of the motorised unit. Slide the eye or threaded
terminal through the motorised unit and hoist it by pulling the halyard.
4.8.1- Fixation of the telescopic section onto the motorised unit
TOP
N
K
4.8.1
Loosen the screw (fig. P) slightly but sufficiently so that the telescopic section can slide inside
the nose of the drum. Lower the telescopic section (fig. N), with its bearing (fig. O), until the
bearing fits in snugly.
4.8.2- Tighten the locking screw (fig. P), which will join the drum to the telescopic section.
Enrouleurs électriques FACNOR
top
M
bottom
O
L
P
M
code /part No document: 29160050150 –
-
First fit the sail feeder (fig. M) to the telescopic
section as indicated.
Fix the feeder to the telescopic section with the
screw provided, tighten until fixed (see 4.11).
4.8.2
L
P
M
rev 07/2018 - page 23/27