Beretta Exclusive C.A.I. Série Manuel D'installation Et D'utilisation page 21

Info 2 shows circuit pressure (fi g. 64)
Fig. 64
Info 3 shows the set heating temperature (fi g. 65)
Fig. 65
Info 4 shows the setted temperature (only water tank with sensor,
fi g. 66).
Fig. 66
Troubleshooting
When a fault appears on the display, the fl ame symbol
out, a fl ashing code is shown and the two symbols
appear either together or separately.
For a description of the faults, consult the following table.
Symbol
FLAME FAILURE BLOCK (D)
LIMIT THERMOSTAT (D)
BURNER THERMOSTAT (D) (MIX R.S.I.)
FUMES THERMOSTAT (D) (R.A.I.)
FUMES OUTLET OR AIR PRESSOSTAT (D) (MIX R.S.I.)
FUMES OUTLET OR AIR PRESSOSTAT (T) (MIX R.S.I.)
INSUFFICIENT SYSTEM PRESSURE (D*)
INSUFFICIENT SYSTEM PRESSURE (T*)
WATER PRESSURE TRANSDUCER (D)
FALSE FLAME (D)
ELECTRONIC BOARD (D)
SANITARY PROBE 1 (T°)
PRIMARY PROBE (T)
LOW TEMPERATURE THERMOSTAT (T)
(D) Permanent
(T) Temporary. In this operating status the boiler attempts to eliminate the fault on its own
(°) Only with external water tank with sensor. The fault code is shown when the boiler is in stand-by
(*) For the "insuffi cient circuit pressure" fault, proceed with the circuit fi lling operations described in the "Boiler functions" chapter.
S.A.R.A. BOOSTER function
If the "winter" mode is selected, the S.A.R.A. Booster function is
activated for the heating circuit. This function allows to reach the
required ambient temperature more quickly.
Depending on the temperature set on the ambient thermostat and
the time taken to reach it, the boiler automatically adjusts the heating
water temperature to reduce operating times, thereby increasing
operating comfort and energy saving.
Fig. 67
goes
and
21
FAULT Alarm
ID
10 YES
20 YES
21 YES
22 YES
30 YES
31 NO
40 YES
41 NO
42 YES
50 YES
51-59 YES
60 NO
71 NO
77 YES
Symbol
NO
NO
NO
YES
NO
YES
NO
YES
YES
YES
YES
YES
YES
YES