Important Safety Information; For Your Safety; Electrical Specifications - Danby DAC8010E Guide D'utilisation Et Soins De Propriètaire

Important Safety Information

READ AND FOLLOW ALL SAFETY INSTRUCTIONS
FOR YOUR SAFETY: Read these instructions carefully before operating the unit.
ELECTRICAL
SPECIFICATIONS
1) All wiring must comply with local and national electrical codes and must
be installed by a qualified electrician. If you have any questions
regarding the following instructions, contact a qualified electrician.
2) Check available power supply and resolve any wiring problems
BEFORE installing and operating this unit.
3) This 115V air conditioner uses 7 or less nameplate amps and may be
used in any properly wired, general purpose household receptacle. See
Table 1 for specifications for individual branch circuit.
4) For your safety and protection, this unit is grounded through the power
cord plug when plugged into a matching wall outlet. If you are not sure
whether your wall outlet is properly grounded, please consult a qualified
electrician.
5) The wall outlet must match the 3-prong plug on the service cord
supplied with the unit. DO NOT use plug adapters. See Table 2 for
receptacle and fuse information. If it is necessary to use an extension
cord to connect your air conditioner, use an approved "air
conditioner" extension cord only (available at most local hardware
stores).
6) The rating plate on the unit contains electrical and other technical data.
The rating plate is located on the right side of the unit, above the power
cord.
Suggested Individual Branch Circuit
Nameplate Amps
7
*Based on copper wire at 60°C temperature rating.
Rated Volts
Amps
Wall Outlet
Fuse Size
Time Delay Fuse
(or Circuit Breaker)
3
TABLE 1
*AWG Wire Size
AWG- American Wire Gauge
TABLE 2
Receptacle and Fuse Types
16
125
15
15
Plug Type