Greenlee SITE-RITE Manuel D'instructions page 6

Working Past an Obstruction
Example 1:
1. Determine the center-to-center distance. Use one of these two
methods:
• Find the appropriate multiplier in the Offset Table, Column
2. (For 45 ° x 45 ° , the multiplier is 1.4). Multiply the height
of the obstruction by the multiplier. (10" x 1.4 = 14).
• See the Greenlee Speed Guide for Offsets. In the Offset
Depth Inches column, find the row with the appropriate
amount of offset. Find the Center-to-Center column under
the appropriate OFFSET ANGLE. The distance shown at the
intersection of the appropriate row and column is the
center-to-center distance. (Under Offset Depth Inches, see
the row labeled "10". Read to the right to find the Center-to-
Center distance under 45 ° x 45 ° . The number shown is 14").
2. Mark the conduit as shown.
3. See the bending instructions.
6
Site-Rite
Working Past an Obstruction
45° x 45°, 10 inches of offset
Greenlee Textron / Subsidiary of Textron Inc.
®
/ Site-Rite II
®