Telecom Behnke 10 Serie Mode D'emploi page 54

Instructions for Series 10
GB
Dimensioning
Problem
Unable to enter Set-
up mode
54
Cause
Manual call answering enabled
The telephone used for remote
configuration does not send DTMF
dialling tones.
Wrong security code entered
Impossible to enable remote con-
figuration due to audio feedback.
Action
Call the device, press a button,
enter the Set-up mode, enter 03 1
#, hang up.
You need a telephone with DTMF
dialling (= a telephone that can
send DTMF dialling tones) for
remote configuration. Certain net-
work telephones require pressing
a button or entering an activation
code to send DTMF dialling tones.
For further information, please
contact your telephone system
administrator.
Upon entering a wrong security
code, the Behnke Series 10 Inter-
com station will produce an error
tone and terminate the connec-
tion. Enter the correct security
code (default setting:
0 0 0 0). If the security code has
been changed and is no longer
available, contact the distributor
of your device.
Enable remote configuration by
pressing the * key within two
seconds after the connection has
been established and stop audio
feedback, e.g. by reducing the
volume.
www.behnke-online.com