Telecom Behnke 10 Serie Mode D'emploi page 53

Problem
The relay activation
code does not acti-
vate the relay
Voice message,
illumination and
additional amplifier
do not work.
www.behnke-online.com
Cause
1) Wrong code or no code
recorded
2) The telephone used for remote
configuration does not send
DTMF dialling tones.
No power supply available.
Instructions for Series 10
Dimensioning
Action
1) Use configuration steps 10 or
11 to record two individual relay
activation codes. Depending on
the operations mode, these codes
may be used differently, e.g.
enabling or disabling the relay
or turning off completely. Please
refer to the chapter Configuration
and Set-up.
You need a telephone with DTMF
dialling (= a telephone that can
send DTMF dialling tones) for
remote configuration.
Certain network telephones requi-
re pressing a button or entering an
activation code to send DTMF di-
alling tones. For further informati-
on, please contact your telephone
system administrator.
Make sure the additional 15 V
+/- power supply unit has been
installed properly. Using voice
messages, illumination and the
additional amplifier all require an
additional power supply.
GB
53