Telecom Behnke 10 Serie Mode D'emploi page 48

Instructions for Series 10
GB
Configuration and Set-up
Code Parameter
8 = play message no. 8 (long message)
52 9 = play message no. 9 (long message)
Upon entering configuration step code 52 and the corresponding
no. of the message to be played, the device will automatically
play the message in question. Playing the message will automa-
tically stop after the message has elapsed. You may also stop
the message playing by pressing the # key.
Please note: You may only play the long messages no. 7, 8 and
9 after you have previously set a corresponding amount of long
messages under configuration step code 50.
Voice message during direct call: Default setting: 0 0 0
58 x [beep] y [beep] z [beep]
x = voice message before the direct call number is dialled
y = voice message while waiting for the call to be picked up
z = voice message after the called party has picked up
The following entries are permitted for x; y and z:
0 = No voice message
1 = Play voice message no. 1
9 = Play voice message no. 9
Use this configuration step to set up to 3 voice messages to be
played during a direct call (dialling of a number previously stored
in the device). During this configuration step, the device requires
the entry of three digits from 0 to 9 to specify the voice messages
to be played. The first cypher determines the voice message to be
played prior to dialling the telephone no., e.g. a message like "Di-
rect call activated" (entering the digit '0' means that no message
will be played). The second cypher determines the voice message
to be played repeatedly while the connection is being establis-
hed, e.g. a message like "Please hold the line." The third cypher
determines the voice message to be played once the called party
picks up the call. This message will only be played to the called
party, e.g. a message like "Call from your intercom system." This
configuration step will affect all direct calls.
For example:
Provided that you recorded the following voice messages via
configuration step code 51:
1. Voice message no. 1 (51-1): "Direct call activated."
3. Voice message no. 3 (51-3): "Please hold the line."
9. Voice message no. 9 (51-9): „Call from your intercom system."
Making the following entry will result in these voice messages to
be played during a direct call:
58 1 [beep] 3 [beep] 9 [beep] #
In case the message "Direct call activated." should not be
played, make the following entry:
58 0 [beep] 3 [beep] 9 [beep] #
48
Confirmation
#
#
#
www.behnke-online.com