Telecom Behnke 10 Serie Mode D'emploi page 49

Code Parameter
Silent connection and call answering:
70 Default setting: 0
0 = enabled
1 = disabled
Use this configuration step to determine when the speaker
will be activated during calls from the device. In case silent
connection is enabled, the signals indicating a connected call,
a busy line or error messages will not be played via the speaker.
Disabling the silent connection option will result in the speaker
being activated upon device activation.
In case silent connection is enabled, the device will wait for
the called party to pick up before a communication channel is
opened.
Label illumination: Default setting: 1
73 0 = turned off
1 = turned on
Use this step to turn label illumination on/off. Requires an addi-
tional 15 V power supply.
Extended configuration Default setting: 0
900 0 = disabled
1 = enabled
The following configuration may only be adjusted with enabled
extended configuration.
Timeout for call answering: Default setting: 60
9910 0 = connection interval
1 = 1 second
:
250 = 250 seconds
Use this configuration step to set the amount of time the device
waits for a call to be picked up according to configuration step
58 or the special symbol *8xx respectively.
Debounce time: Default setting: 3
945 Debounce time buttons 1-3, alarm button
0 = 0 ms
1 = 128 ms
2 = 256 ms
:
9 = 1152 ms
This configuration step will set the debounce time for all keys
(i.e. the amount of time a key needs to be pressed before it will
be recognised as an active key).
www.behnke-online.com
Instructions for Series 10
Configuration and Set-up
Confirmation
#
#
#
#
#
#
#
#
:
#
#
#
#
:
#
GB
49