Télécharger Imprimer la page

Fein ALG30 Mode D'emploi page 13

Masquer les pouces Voir aussi pour ALG30:

Publicité

OBJ_BUCH-0000000028-003.book
OBJ_BUCH-0000000028-003.book Page 13 Wednesday, December 12, 2018 9:13 AM
LED indicator
The charge indication of charger and battery may temporarily vary for technical reasons.
Repair and customer service.
Once per week; more often in case of frequent usage:
– Keep the contacts in the slide-on shoe clean.
– Only dry-clean electrical contacts.
– Ensure that metal chips do not enter the battery-
charger housing.
When the battery charger's power cord is damaged, it
must be replaced by FEIN or by an authorized FEIN Serv-
ice Agent, in order to avoid hazardous situations.
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your battery charger may include
only a part of the accessories described or shown in this
Instruction Manual.
Meaning
Charging procedure
continuous green light
flashing LED
Rapid charging starts.
The rapid charging is active.
Charge condition of battery ≤ 25%
The rapid charging is active.
Charge condition of battery ≤ 50%
The rapid charging is active.
Charge condition of battery ≤ 75%
Rapid charging is over.
Charge condition of battery ≥ 75%
LED continuously OFF while battery is attached on charger:
Rapid charging is over.
Battery fully charged for more than 1 hour on the charger.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH, C-D1_IA,
D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out battery chargers and accessories
should be sorted for environment-friendly recycling.
Dispose of batteries only when discharged.
For batteries that are not completely discharged, insulate
the terminals with tape as a protective measure against
short-circuiting.
en
13

Publicité

loading