Wi-Fi Module; Storage - CASO DESIGN SousVide Garer SV 1200 Smart Mode D'emploi

5. You can hear a signal and the operation indicator is flashing when the desired
temperature is reached..
6. The device will beep once desired temperature is reached. Place the vacuumed food
into the cooking vessel. If needed weight the vacuumed bags.
7. The device counts down the time and will beep again, once time is over. Then "END"
is shown in display.
8. When you want to change the settings please press
settings as described above.
9. You can deactivate the device by pressing
to standby mode.
► Risk of scalding! Carefully remove the food.
► If the device should indicate "EE1" in the LED display after switching on even though
the water filled in is above the minimum level, please add some salt to the water and
stir well.

18.2 Wi-Fi Module

Press the button
once and
LAN (pairing process), the
constantly after a successful connection. If
the configured W-LAN could be achieved.(reception level is too low or W-LAN name or
access have been changed or W-LAN password is wrong). If the pairing process has not
yet been carried out, please follow steps mentioned in pairing instructions.

19 Storage

Store the unit in its upright position, out of the reach of children.
► Turn off the device after use. So you can avoid unnecessary energy consumption
and ensure your safety.
► Always unplug the appliance from its outlet immediately after using and before
cleaning.
Warning
Note: EE1
briefly to activate the integrated W-LAN module.The device beeps
starts to flash slowly. If the device is aleady connected to your W-
PLEASE NOTE
for 3 seconds. The device will switch
flashes for approx. 3-5 seconds and lights up
continues to flash, no connection to
for 3 seconds and change
38