Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Used batteries can be returned free of charge to our branches or
head office in Hirschau or, as always, to your local authority waste
management centre (recycling centre) who are obligated to accept
the batteries.
Make a contribution to protecting the environment!
Switching on/off
Press the On/Off button (4) to switch the hand thermometer on or
off.
Connecting the temperature sensors
Connect a commercial K-type temperature sensor to the input T1 (1)
and T2 (2) (only for K102). If the temperature sensor is defective or
not properly connected, "----" will appear in the LCD display.
Take note that the maximum input voltage at the input, 60V DC
or 24V AC, must not be exceeded!
Selecting the temperature unit °C/°F
When the hand thermometer is switched on the temperature is
shown in degrees Celsius. To change the temperature to degrees
Fahrenheit press the °C/°F button (8). To display the temperature
back in degrees Celsius press the °C/°F button (8) once again.
Data-Hold function
The hand thermometer is equipped with a Data-Hold function. This
allows the current temperature reading in the display to be "frozen".
To freeze the temperature reading press the hold button (6). When
activated the Data-Hold function will be indicated in the LCD display
H
with the "hold" symbol "
" (1). The hand thermometer continues to
18
Publicité
Table des Matières
