Start Up Instructions; List Of Materials; Mounting The Handle - Garland SCAR 102 E Manuel D'instructions

English

6. START UP INSTRUCTIONS

6.1. LIST OF MATERIALS

This machine includes the following elements that you
will find inside the box:
1. Scarifier (1).
2. Catcher (2).
3. Top handle (1).
4. Intermediate handle (2).
5. Lower handle (2).
6. Lower handle screws (2).
7. Handle screw and knob (4).
8. Hook for cable (1).
9. Scarifying cylinder (mounted on the machine) (1).
10.Aerator cylinder (1).
• Instruction manual.
Remove carefully all the elements from the box and
make sure that all listed parts are included.
Due to the quality controls done at the factory it is
highly improbable that your machine has any faulty
part or that any elements are missing. If you find any
damaged part or there are any elements missing,
do not use the machine until the problem has been
solved or you have been given the missing parts.
Usage of the machine with defective or missing parts
is dangerous and could result in personal injuries.

6.2. MOUNTING THE HANDLE

The handle comes unmounted from the manufacturing
plant. To mount the handle:
1. Place the scarifier (1) on a flat surface.
2. Insert the lower handles (5) on
the scarifier as shown in the
figure and hold in place with
the screws (6).
3. Place the intermediate handle
(4) on the lower handle and
hold in place with the screws
and knob provided (7).
4. Place the hook for the
cable (8) on the top handle
(3).
5. Place the top handle (3) and hold to the lower
handle using the two screws and knobs provided
(7).
6.3 INSTALLATION OF THE CATCHER
Place the catcher (2) on the scarifier by hooking the
catcher on the hooks on the rear part of the machine
(3). To do this, hold the catcher by the top handle
provided with your right hand, lift the security trap (1)
with your left hand up to its maximum point and hook
the catcher on the machine.
1
3
28/92
2