Sagem Fax ATA 101S Livret Utilisateur page 13

Sagem_Fax_ATA101S.book Page 9 Jeudi, 21. février 2008 5:09 17
The second file includes the setup commands common to the ATAs
(for example, SIP proxy, coder used, fax protocol used).
The example below is the content of the "common_parameters.txt"
file (named as announced
"voipprovider.org" as domain, registrar and SIP proxy (for all the ATAs
in the network):
sip
deregister all
confighost vif0 -o -useproxy yes -h
voipprovider.org -p 5060 -rtpmin 17000
-rtpmax 18000 -keepalive yes 20
configreg voipprovider.org
configproxy voipprovider.org
..
save
This CLI command file must be in ASCII format.
To create the
Communications or your dealer to obtain the ATA's
list of CLI commands.
The third file contains the setup commands specific to a given ATA,
for example SIP account settings if the infrastructure uses proxy, or if
not, a routing table.
The name of this file is suffixed by the MAC address of the ATA with
which it is associated. There must be a corresponding file of this type
for each ATA in your network.
User guide
in the entry file).
Note
ASCII file, contact Sagem
It defines
9