Removing The Optional Hdmi Module - Dell OptiPlex 3000 Manuel D'entretien

Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2. Align and place the Type-C module into the optional I/O module slot from the inside of the computer chassis.
3. Connect the Type-C cable to the connector on the system board.
4. Connect the DP cable to the video cable connector on the system board.
5. Replace the two (M3x3) screws to secure the Type-C module to the computer chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in

Removing the optional HDMI module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicates the location of the optional HDMI module and provides a visual representation of the removal
procedure.
NOTE: Optional VGA and DisplayPort modules have similar procedure as optional HDMI module.
24 Retrait et installation de composants
after working inside your
before working inside your
computer.
computer.