General Power Tool Safety Warnings - Makita DJS160 Manuel D'instructions

ENGLISH (Original instructions)
1. Button
2. Red indicator
3. Battery cartridge
4. Star marking
5. Switch lever
6. Indicating lamp
7. Hex wrench
SPECIFICATIONS
Max. cutting capacities
Min. cutting radius
Strokes per minute (min
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
Cd
............ Only for EU countries
Ni-MH
Li-ion
Do not dispose of electric equipment or
battery pack together with household
waste material!
In observance of the European
Directives, on Waste Electric and
Electronic Equipment and Batteries
and Accumulators and Waste Batteries
and Accumulators and their
implementation in accordance with
national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling
facility.
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
4
Explanation of general view
8. Screw
9. Center blade
10. Thickness gauge
11. Side blade
12. Hex socket head bolt
13. Oil supply
14. Pin
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Aluminum up to 200 N/mm
-1
)
END004-6
ENE037-1
GEA010-1
DJS160
2
1.6 mm (16 ga.)
2
1.2 mm (18 ga.)
2
2.5 mm (13 ga.)
250 mm
4,300
362 mm
1.9 kg
D.C. 14.4V
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS SHEAR SAFETY
WARNINGS
1. Hold the tool firmly.
2. Secure the workpiece firmly.
3. Keep hands away from moving parts.
4. Edges and chips of the workpiece are sharp. Wear
gloves. It is also recommended that you put on
thickly bottomed shoes to prevent injury.
5. Do not put the tool on the chips of the workpiece.
Otherwise it can cause damage and trouble on the
tool.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
8. Do not touch the blade or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
9. Avoid cutting electrical wires. It can cause serious
accident by electric shock.
15. Limit mark
16. Brush holder cover
17. Notch
18. Screwdriver
19. Brush holder cap
DJS161 DJS100
1.0 mm (20 ga.)
0.7 mm (23 ga.)
2.5 mm (12 ga.)
2.0 kg 1.9 kg
D.C. 18V D.C. 14.4V
DJS101
30 mm
4,300
364 mm
2.0 kg
D.C. 18V
GEB067-1