Names And Functions Of Parts; Main Unit - Kenwood KRF-V6070D Mode D'emploi

Names and functions of parts

Main Unit

Speaker indicator
CLIP indicator
RDS indicator
TONE indicator
LOUDNESS indicator
96kHzfs indicator
STANDBY
ON ⁄ STANDBY
SPEAKERS ON ⁄ OFF
POWER
ON OFF
PHONES
1 POWER ON/OFF key
Use to turn the main power ON/OFF.
2 ON/STANDBY
key
Use to switch the power ON/STANDBY when
the POWER is turned ON.
STANDBY indicator
3 DIMMER key
Use to select the REC MODE.
Use to adjust the brightness of the display.
4 LISTEN MODE key
Use to select the listening mode.
5 Surround LED (light-emitting diode)
indicators
ACTIVE EQ mode LED indicator
Lights when the receiver is in the ACTIVE EQ
mode.
DTS mode LED indicator
Lights when the receiver is in the DTS mode.
Standby mode
While the standby indicator is lit, a small amount of power is supplied to
the system to back-up the memory. This is called standby mode. Under
the condition, the system can be turned ON by the remote control unit.
6 EN
Frequency display,
Input display,
Preset channel display,
Surround mode display
MUTE indicator
A B
Speaker selection indicators
Input channel indicators
Output channel indicators
DOLBY
DIMMER LISTEN MODE ACTIVE EQ DTS
DIGITAL EX
ACTIVE EQ INPUT MODE BAND AUTO MEMORY
%
DOLBY DIGITAL EX mode LED indicator
%
Lights when the receiver is in the Dolby
Digital EX mode.
6 SOUND key
Use to adjust the sound quality and the
ambience effects.
7 MULTI CONTROL knob
)
Use to control a variety of settings.
8 INPUT SELECTOR knob
•
§
Use to select the input sources.
9 VOLUME CONTROL knob
0 PHONES jack
Use for headphone listening.
! SPEAKERS ON/OFF key
(
Use to turn the speakers ON/OFF.
@ ACTIVE EQ key
§
Use to select ACTIVE EQ setting.
# INPUT MODE key
Use to switch between full auto, digital and
analog inputs.
DTS indicator
Band indicators
DOLBY DIGITAL
indicator
PRO LOGIC
indicator
Display
MULTI CONTROL INPUT SELECTOR
SOUND
SETUP
§
¶
%
*
*
(
*
(
8
Connection at POWER ON/OFF key
The power in this equipment will not be completely cut off from the AC
wall outlet when the main switch is turned OFF.
AUTO DETECT
indicator
6CH INPUT indicator
DIGITAL indicator
AUTO indicator
MEMO. indicator
ST. indicator
TUNED indicator
DSP indicator
STEREO indicator
VOLUME CONTROL
DOWN UP
MUTE
$ BAND key
Use to select the broadcast band.
% AUTO key
Use to change "TAPE" indication to "MD".
Use to select the auto tuning mode.
^ MEMORY key
Use to store radio stations in the preset
memory.
& SETUP key
Use to select the speakers' settings etc.
* MUTE key
Use to temporarily mute the sound.
¡
*
¡
¡
%
(