Unpacking; Preparing The Remote Control - Kenwood KRF-V6070D Mode D'emploi

Before applying the power

Unpacking

Unpack the unit carefully and make sure that all accessories are
present.
FM indoor antenna (1)
Remote control unit (1)
RC-R0825
If any accessories are missing, or if the unit is damaged or fails to operate,
notify your dealer immediately. If your unit was shipped to you directly,
notify your shipper immediately. Kenwood recommend that you retain
the original carton and packing materials in case you needs to move or
ship the unit in the future.
Keep this manual handy for future reference.
4 EN
AM loop antenna (1)
Batteries (R6/AA) (2)

Preparing the remote control

Loading the batteries
1 Remove the cover.
3 Close the cover.
• Insert two AA-size (R6) batteries as indicated by the polarity markings.
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER RCVR key on the remote control. When the power comes
ON, press the key you want to operate.
Operating range
(Approx.)
6 m
POWER
RCVR
¢
4
• When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
2 Insert the batteries.
Remote sensor
Infrared ray system
+ +
+