Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood KRF-V6070D Mode D'emploi

Normal playback

Preparing for playback

Some preparatory steps are needed before starting playback.
SPEAKERS
ON/OFF ON/STANDBY
POWER AUTO
ON/OFF
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER ON/
OFF and ON/STANDBY key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2,
DVD/6CH jacks, make sure that the input mode setting is correct for the
type of audio signal to be used.
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is "TAPE". To change the
source to "MD", follow the steps below:
1 Use the INPUT SELECTOR knob to select "TAPE".
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to "MD".
• To return to the original indication, repeat procedure 2.
Setting the speaker status
The speaker indicator lights up.
Press the SPEAKERS ON/OFF key to switch the speaker on or off.
18 EN
INPUT SELECTOR
8

Listening to a source component

Input
Selector
¢
4
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "DVD/6CH"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOL +/– keys to adjust
the volume.
VOLUME CONTROL
INPUT SELECTOR
+ +
VOL
+