Replacing The Bulb - Glem Gas GHS972IX Mode D'emploi

CARBON FILTER REPLACMENT
Activated carbon filter can be used to trap odors. Normally the activated carbon filter should
be changed every 3 to 6 months according to your cooking habits. The installation procedure of
activated carbon filter is as below:
(1) Before installing or replacing the carbon filters, disconnect the mains power to the unit.
(2) Press the filter lock and remove the mesh filter.
(3) Turn the old carbon filter on both sides of the motor anti-clockwise. Replace the carbon
filters with the new carbon filters.
(4) Replace the mesh filter.
(5) Connect the mains power supply to the wall socket.
NOTE:
 Make sure the filter is securely locked. Otherwise, it would loosen and cause dangerous.
 When activated carbon filter attached, the suction power will be lowered.
REPLACING THE
 Remove the grease filter.
Use a tool or the hand to press the spring splinter of both sides of LED light to the

until the light is pressed out, see pic 1.Then slightly pull the light connecting wire out, and
dismantle the terminal of the light connecting wire. See pic 2.
 Apply the reverse procedure to install the light back.
• ILCOS D code for this lamp is: DSR-1.5/65-S-64
– LED modules –round lamp
– Max wattage: 2x1.5 W
– Voltage range: DC 12V
– Dimensions:
BULB:
70
inside,