Step 2 - Inserting Batteries Into The Remote Control; Demo Function; Placement Of Speakers - Panasonic SC-PM21 Mode D'emploi

Step 2 Step 2
- Inserting batteries into the remote control - Inserting batteries into the remote control
S S tep tep 3 3

- DEMO function

- DEMO function

Placement of speakers

Placement of speakers
Speakers are designed identically so that no left or right channel orientation is necessary.
• These speakers do not have magnetic shielding. Do not place them near televisions, personal computers or other devices
easily influenced by magnetism.
• To avoid damage to the speakers, do not touch the speaker cones if you have taken the nets off.
Note
• Keep your speakers at least 10 mm (
Use only the supplied speakers.
• The combination of the main unit and speakers provide the best sound. Using other speakers can damage the unit and sound
quality will be negatively affected.
Caution
• Use the speakers only with the recommended system. Failure to do so can damage the amplifier and speakers,
and can cause fire. Consult a qualified service person if damage occurs or if a sudden change in performance is
apparent.
• Do not attach these speakers to walls or ceilings.
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of time.
Store in a cool, dark place.
• Do not use rechargeable type batteries.
• Mishandling of batteries can cause electrolyte leakage which can damage
items the fluid contacts and may cause a fire.
Do not:
• mix old and new batteries.
• use different types at the same time.
• heat or expose to flame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
■ Use
• Aim at the remote control sensor, avoiding obstacles, at a maximum range of
7 m (23 feet) directly in front of the unit.
Refer to page 6 for remote control signal sensor position.
When the unit is first plugged in, a demonstration of its functions may be shown
on the display.
If the demo setting is off, you can show a demonstration by selecting "DEMO
ON".
Press and hold [STOP 7, -DEMO].
The display change each time the button is held down.
DEMO OFF
While in standby mode, select "DEMO OFF" to reduce power consumption.
13
/ ˝) away from the system for proper ventilation.
32
DEMO ON
5
RQT7968