Overview of controls
Do the procedures with the remote control. You can also use the buttons on the main unit if they are the same.
A
Standby/on switch [`], [1]
Press to switch the unit from on to standby mode or
vice versa. In standby mode, the unit is still
consuming a small amount of power.
B
Select the audio source
On the remote control:
Press the corresponding button to select the source.
On the main unit:
C
Basic playback control
D
View the setup menu
E
View the content information
F
Select or confirm the option
G
Open or close the disc tray
H
Decrease the brightness of the display panel
To cancel, press the button again.
I
Adjust the volume level
J
Mute the sound
To cancel, press the button again.
"MUTE" is also canceled when you adjust the volume
or when you switch off the system.
K
View the play menu
L
Select the sound effects
M
Display panel
N
Remote control sensor
Distance: Within approximately 7 m (23 ft)
Angle: Approximately 20° up and down,
30° left and right
6
O
USB port (
)
P
Disc tray
Q
Select "BLUETOOTH" as the audio source
To start Bluetooth
pairing, press and hold the
®
button.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
(not supplied)