Nuna pipa Mode D'emploi page 39

1
- Tighten vehicle belt while pushing carrier firmly
into vehicle seat. Lock the vehicle belt. Refer to
vehicle owner's manual for instructions. If you
cannot lock the vehicle belt, you must use the
provided locking clip.
Refer to your vehicle owner's manual to determine
if shoulder belt will lock. If necessary, connect
the shoulder and lap belts with a locking clip.
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
This belt MUST be locked to prevent movement
of the lap portion of the belt. You must use the
provided locking clip.
Check the Installation
Blue line must be level with ground.
Vehicle belt must be buckled, tight and locked.
Carrier must be stable – Carrier should not move
side to side more than 25 mm (1 in.) at belt path.
Locking Clip Use
Tighten the buckled belt by pushing down hard on
the infant restraint and pulling hard on the shoulder
belt. While pushing down on infant restraint, pinch
the two straps together behind the buckle tongue.
Unbuckle the belt without allowing it to slip
2
- Connect lap and shoulder belts with locking
clip. Rebuckle belt. Check that lap belt does
not move by pulling and pushing hard on infant
restraint. If belt loosens or lengthens, repeat
procedure.
3
- The locking clip should be 12.5 mm (1/2 inch)
from the buckle.
38 PIPA instructions