Maintenance And Storage - Kong FROG Mode D'emploi

height of a potential fall, rope paid out and the "pendulum"
effect in order to avoid all possible obstacles (e.g. ground,
material rubbing against the rock face, etc..).
F) Resistance of anchors point, either natural or fixed into
the rock, is not always granted and therefore it is essential
for the user to carefully judge the situation beforehand to
guarantee adequate protection.
G) It is strictly forbidden to modify and/or repair the product:
The Manufacturer shall not be held liable for any damages,
injuries or death caused by: improper use, product
modifications, repairs by unauthorized persons or use of
non-original spare parts
H) During transportation avoid exposure to U.V. radiations
and sources of heat and avoid contact with chemical
reagents or other corrosive substances, and adequately
protect any pointed or sharp parts. Warning: never leave
your equipment in a car under the sun!
I) For the sake of your own safety, it is essential to make
sure that the product was sold to the public: complete, in
their original packaging and with the relative information.
It is compulsory for dealers selling products in countries
other than the original destination to check and supply the
translation of this information.
L) This product has been tested and inspected piece by
piece in conformity with the Quality System certified to
the UNI EN ISO 9001 international standard. Personal
protective equipment is certified by the notified body
indicated in the relevant product instructions. Warning:
laboratory tests, inspections, information and norms
do not always manage to reproduce what actually
happens in practice so that the performances under
real conditions when using the product in a natural
environment can often differ considerably. The best
information can be gained by continual practice under
the supervision of skilled and qualified instructors.
2 – WORKS AT A HEIGHT
Additional information
against falls from a height
For the sake of safety in case of falls from a height, it is essential to:
assess the risks and make sure that the whole safety
system, where this device is only a component, is reliable
and safe;
- prepare a rescue plan to deal with any emergencies
possibly arising while the device is being used,
- make sure that work is done in such way as to reduce
potential falls and relevant heights to a minimum,
- make sure that the fall arrest systems conform to the EN
363 standard, and especially that:
- the anchor point conforms to the EN 795 norm,
guarantees minimum strength of 12 kN and is placed
preferably above the user,
- that the parts being used are suitable and certified
conforming to the standards applicable to the specific
works at a height that you are going to perform.
Important: A fall arrest device mandatorily requires the use
of a complete harness as per applicable norms.
3 – MAINTENANCE AND STORAGE
Product maintenance consists of:
- cleaning: frequently wash the product with lukewarm
(max. 40°C) drinking-water where necessary, you can
also add some gentle detergent.
dry naturally away from direct sources of heat, do not
centrifuge.
- disinfection (if necessary): soak the product for an hour
for protective equipment
Rinse and leave to