Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Self-washing cycle: with machine on, carry out the
following operations:
-
Remove the overflow from the tank and wait
for the tank's emptying (for machines with
drain pump, look at the instructions in the
specific paragraph),
-
Close the door of the dishwasher,
-
Keep pressed the cycle button ''C'' during 3
seconds: lamp ''2'' flashes during all the length
of the 5 or 10 minutes cycle, according to the
rinse's duration fixed by default.
ACHIEVEMENTS
Any deficiency in the washing process is apparent
when dirty residuals are visible. An insufficient rinsing
might cause any halos: in this case, check that the
rinsing jets are clean and there is a sufficient pressure
in the water distribution network.
In the case that residuals are present, check that:
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are correct.
GLASSES POSITIONING
In order to obtain a successful dishwashing, it is
suitable to take care of the way dishes are placed. It is
suitable to place glasses, inside the wire basket with
the concave side towards the bottom. Place mixed
cutlery in a vertical position into the suitable container
minding not to cram them and with hafts towards the
bottom (see the drawing).
Adding Rinse Aid and Detergent
CAUTION: Only use detergent and rinse aid which
are suitable for commercial washers, a non-foaming
industrial alkaline detergent.
Do not use any soap intended for a residential
dishwasher. This leads to large amounts of foam
building up in the washer and will void your
manufacturers warranty.
CAUTION: Detergents for commercial dishwashers
cause corrosion. Always follow the instructions on the
packaging and drums.
CAUTION: Do not mix different detergent products,
this could cause the dosing pump to break down due
to crystallization.
NSF
3-2009
detergent
and
dispensers
Feeders (rinse-aid, or detergent) are OPTIONAL.
When provided see instructions on page 27 in this
manual.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3
Afterwards push button "F" for 3 seconds.
Alternatively are flashing the control lamp "E" and
the cycle lamp (chosen before)
The discharge will stop automatically after 5
minutes. The control lamps will stop flashing.
The drain can be stopped at any time by pressing
again button ''F'' .
Please note: in case the door is open the control
lamp "E" will continue flashing.
Reinstall the flow over and shut the door.
CLEANSING AGENTS
Choice of the suitable cleansing agent is an essential
condition if you want to obtain extremely good
washing results as regards hygienic results. It is then
important to consider some points. First of all only
highly alkaline and chlorine-active antifoam products,
especially made for industrial dish-washing machines,
must be used and they must be produced by well-
known reliable Firms. Mean concentration of the
cleansing agents in powder must be 1,5÷2,5 g/lt.
10
requirements
for
chemical
sanitizer
Publicité
Table des Matières
