Bosch PS42 Mode D'emploi page 10

INTENDED USE
This tool is intended for the fastening and
loosening of bolts, nuts and various threaded
fasteners. This tool is not intended for use as
a drill.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
BRAKE
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is es-
pecially useful in the repetitive driving and re-
moval of screws.
VARIABLE SPEED CONTROL
SELECTOR
The speed of the power tool can be adjusted
by toggling the variable speed control on the
top of the impact driver/wrench. The speed of
the impact driver/wrench is indicated by the
indicator lights on the top of the impact driver/
wrench located next to the variable speed
control selector button. The lowest speed set-
ting is indicated by one green LED light turned
and the hightest setting is indicated by both
green LED lights turning on (Fig. 1).
No-Load
Setting 1 0-1200/min
Setting 2 0-2600/min
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger
prevent accidental starts and accidental dis-
charge.
Your tool is equipped with a forward/reversing
lever and trigger lock located above the trigger
(Fig. 4). This lever was designed for changing
rotation of the bit, and for locking the trigger in
an "OFF" position.
2610034966.indd 10
Operating Instructions
Impact Rate
Speed
0-2700/min
0-3100/min
in "OFF" position to help
For forward rotation, (with chuck pointed away
from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to the
center off position.
Do not change direction
of rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to the
tool.
Fig. 4
BUILT IN WORK LIGHT
Your tool is also equipped with three work
lights for better visibility when driving. The
lights turn on when the trigger is pulled or
when the light button on the top of the drill is
activated. The light will automatically turn off
within 10 seconds after releasing the trigger
or may be turned off manually by pressing the
light button on the top of the drill (Fig. 5).
WorK ligHt on/
oFF bUtton
10
Fig. 5
10/1/15 10:14 AM