Vacon 100 industrial Manuel D'installation page 7

®
UK: VACON 100 drive supply switch
7
Attach the drive supply
switch screws.
8
Tighten the supply cable
screws on the drive supply
switch according to the
tightening torques given in
Table 1 and Table 2.
Please also check the
tightening of the factory-
installed cable connection
screws on the right side of
the drive supply switch.
9
MR4: Lead the data
cable "D" under the drive
supply switch and attach it.
MR5-MR7: Lead the data
cable around the drive
supply switch to the
control terminal.
NOTE 1! Protect the data
cable as close to the
terminal as possible with
the cable insulation tube!
NOTE 2! See detailed
cable installation
instructions in the
®
VACON 100 installation
manual!
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
2T1 1L1
4T2 3L2
6T3 5L3
vacon • 7
uk