EGO Power+ ED0800 Guide D'utilisation page 23

To install the blade
1. Remove the battery pack.
2. Position the inner flange removed in
step 6 of the "To remove the blade"
section onto the motor shaft with
the bulge of the inner flange facing
outwards (Fig. 15).
3. Install the new blade onto the inner
flange.
WARNING:
flange must engage the blade's mounting
hole (Fig. 16). There should not be any
clearance between the blade and the
inner flange flat surface.
4. Mount the outer flange and the nut
onto the shaft, and pre-tighten the
nut COUNTERCLOCKWISE by hand.
5. Rotate the blade to align the slot in
the flange with the hole in the gear
case (see Fig. 12).
6. Insert the hex wrench provided
into the aligned holes to act as a
stabilizer. Use the multi-function
wrench provided to tighten the nut
COUNTERCLOCKWISE securely onto
the shaft (Fig. 17).
7. Insert a new cotter pin into the hole in the motor shaft. Bend the two ends of the
pin in opposite directions with a needle nose pliers (not included) (see Fig. 12).
The bulge of the inner
56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC
15
16
Inner Flange
17
Stabilizer
Bulge Outwards
Bulge of the inner flange
engaging the blade
Blade
Multi-function
Wrench Provided
23