Troubleshooting - Windsor Radius 30 Mode D'emploi

Fault
Appliance cannot be started
Engine is running but machine is not moving
Device comes to halt while climbing a slope
Machine is not sweeping properly
Dust gathers in the machine
Poor cleaning performance at edges
Side-brush raising does not function
The new roller brush brushes against the waste
container
14
English

Troubleshooting

Remedy
Close appliance hood
Charge the batteries
Check overload fuse
Inform Windsor Customer Service.
Adjust the Bowden cable of the acceleration drive
Checking the V-Belt
Inform Windsor Customer Service.
Drive over a path with lesser slope
Check overload fuse
Adjust the Bowden cable of the acceleration drive
Checking the V-Belt
Inform Windsor Customer Service.
Check roller brush and side brushes for wear, replace if necessary.
Check function of bulk waste flap
Release the Bowden cable of the bulk waste flap (adjustment screw)
Check belts for tension and functioning; replace, if required
Adjust roller mirror
Replacing roller brush
Inform Windsor Customer Service.
Check function of bulk waste flap
Release the Bowden cable of the bulk waste flap (adjustment screw)
Check dust filter, clean or replace
Empty waste container
Replace sealing profile at the waste container
Check the seal on the dust filter
Check sealing strips for wear, adjust or replace as required
Adjust side-brush lowering
Replace side brush
Lower the side brushes
Check the drive belt of the side brush
Inform Windsor Customer Service.
Check Bowden cable of the side-brush raising
Inform Windsor Customer Service.
Correct the setting of the sweep track; for this, engage both adjustment levers into the
upper boring (1...3)