Troubleshooting; Technical Data (Vsp 14 (Vsp 18) - Windsor Versamatic plus VSP14 Mode D'emploi

Notes:

Troubleshooting

PROBLEM
Brush not turning
Red light stays on at
lowest brush setting
(#1)
Full bag light on, or
poor suction
Full bag light off
when vacuum hose
is blocked or bag is
full
Back door won't
close
Machine won't turn
on

Technical Data (VSP 14 (VSP 18)

ITEM
Voltage
Vacuum floor
Air flow
Dust bag
Brush motor
Brush width
Brush drive
Brush strip
Height
Width
Weight
16
CAUSE
Hose nozzle not far enough into neck
Brush jammed
Brush strip not fully inserted
Broken belt
Brush worn
Full dust bag
Hose clogged
Neck clogged
Bag not properly installed
Exhaust or motor filter clogged
Back cover leaking air
Sensor out of adjustment
Bag not properly installed
Motor filter not in position
Faulty electrical circuit
120V, 60 hz
8,6 amp
117 cfm
1,3 gal, 3-layer
1,4 (1,8) amp
12 3/4 (16/3/4) inches
Non slip drive belt with electronic overload protection
Replaceable
48 inches
14 (18) lbs
16 (18) lbs
86359940 VERSAMATICPLUS 14 & 18
SOLUTION
Reposition hose nozzle into neck
Turn off machine, clear brush and restart
Push brush strip in all the way
Replace belt
Replace brush strip
Replace bag
Remove and clean hose
Disconnect floor head from vac tank and
clean neck
Re-insert bag correctly
Clean or replace filter
Re-Install dust bag, motor filter and back
cover to ensure tight fit all around
Remove back door and use small screw-
driver to turn screw behind light, counter-
clockwise
Re-insert bag correctly
Re-insert filter correctly
Have machine check by qualified service
person
DIMENSION/CAPACITY