Install Batteries In Wireless Devices; Link All Devices To Wireless Network - Aube Technologies EConnect TA7210 Guide D'installation

2 Install batteries in wireless devices

Thermostat
Install 2 AA alkaline
batteries

3 Link all devices to wireless network

Start wireless setup
Press the EIM Connect button to place it in wireless setup. When the amber light
changes to a green flashing light, you can begin to link devices to the wireless network
(see pages 7-10).
If the amber light changes to a red light
instead, there is another EIM currently in
wireless setup. Press the Connect button
on the other EIM to exit its wireless setup.
If the green flashing light disappears
(after a delay of 15 minutes) before you
have time to link all your devices, press the
Connect button again.
Remote control
(optional)
Install 3 AA alkaline
batteries
* Flashing green: Ready for connection
Steady green: Connection established
Steady red: Connection failure
7
EConnect™ TA7210
Outdoor air sensor
(optional)
Install 2 AA lithium
batteries
Connect button
Connect LED *
69-2472EF—03