Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Guide
System installation at a glance
The equipment interface module (EIM) allows you to control a baseboard heater, a
convector or a fan-forced heater in a 120-volt, 208-volt or 240-volt application from a
EConnect™ wireless thermostat.
EIM in remote
junction box
Electrical
panel
Installation procedure
Install the equipment interface module (EIM) .............................................Pages 3 - 6
1
Install batteries in wireless devices ............................................................................. Page 7
2
Link all devices to wireless network .................................................................Pages 7 - 10
3
Exit wireless setup ............................................................................................................. Page 11
4
Customize thermostat (installer setup)......................................................Pages 11 - 18
5
Mount thermostat and outdoor sensor ......................................................Pages 19 - 20
6
For error codes, see page 20.
To verify the signal strength, see page 21.
To replace a wireless device, see pages 21-22.
For specifications and replacement parts, see page 23.
69-2472EF—03
Heater
Supply wires
SAVE THESE INSTRUCTIONS
Thermostat
Thermostat
Wireless connection
2
EIM in heater
Remote
control
Outdoor
air sensor
Publicité
Table des Matières
