Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6 Mount thermostat and outdoor sensor
Follow the guidelines below when mounting the thermostat:
• Do NOT install the thermostat in an area where it can be exposed to water or rain.
• Avoid locations where there are air drafts (top of staircase, air outlet), dead air spots
(behind a door), direct sunlight or concealed chimney or stove pipes.
• For a new installation, choose a location about 1.5 m (5 ft.) above the floor.
• Install the thermostat on an inside wall facing the heater.
• Keep the thermostat's top and bottom air vents (openings) clean and unobstructed
at all times.
Two mounting plates are provided for mounting the thermostat on the wall or on a
junction box. Use Method A for a slimmer thermostat look. Choose Method B if you
prefer not to make an opening in the wall. Method C must be used for installation on a
junction box.
Recessed mounting on a wall (Method A)
Mark the four corners and join
them to create a rectangular
outline.
Mounting on a
wall (Method B)
Secure the mounting
plate to the wall using
provided wall anchors
and screws.
Cut along the outline to
create an opening in the wall.
Mounting on a junction box
(Method C)
Use mounting plate with no opening.
Secure the mounting plate to
a junction box using provided
mechanical screws.
19
EConnect™ TA7210
Secure the mounting plate to
the wall using provided wall
anchors and screws.
Installing faceplate
Complete the thermostat
installation by pressing
the faceplate against the
mounting plate.
69-2472EF—03
Publicité
Table des Matières
