BedJet VET-800NA Manuel D'utilisation page 7

IMPORTANT INSTRUCTIONS: USER OPERATING MANUAL
BedJet VET Wireless Remote Control:
All BedJet VET operating modes are activated via the wireless radio remote control, there are no
exterior buttons located on the BedJet VET base unit for manual operation. With charged batteries
installed, the remote control keys will light up automatically when picked up, indicating remote is
ready for use. The BedJet VET will beep to acknowledge any command received from the remote
control. The wireless remote control is pre‐paired to your BedJet VET unit at the factory.
However, if your BedJet VET is verified powered ON (power button LED is ON) and wireless remote
buttons light up and are pressed but the BedJet does not activate, then re‐pair the remote control
to base unit.
Pairing a New Remote: Press and hold the "Low Power" button on the back display of the BedJet
VET until it blinks, indicating the unit is in pairing mode. Press and hold the OFF key on your
remote control to complete the pairing. Successful pairing will be acknowledged by three beeps.
Pre‐Programmed
Warming Air Temperatures
Deactivate BedJet VET,
Enter Standby
Audio Mute ON/OFF
Programmable One‐Touch
Memory Setting Recall
Revision 1.0
MODEL SKU: VET‐800NA
Fan Speed, Auto‐Shutoff Timer,
and Warming Air Temperature
Adjustments
Cool Air Mode
Setup functions, see next
page for details
P a g e | 7