IMPORTANT INSTRUCTIONS: USER OPERATING MANUAL
System Operation
Low Power Switch:
Setups with two BedJet VET units plugged into the same AC circuit should set Low Power switch
ON to avoid tripping/overloading the circuit breaker. Installations where only one BedJet VET is
used in a room should leave Low Power Switch OFF to utilize the full power of the system.
WARNING: Failure to comply with the correct Low Power ON switch setting with more than
one BedJet installed on the same room AC branch circuit may result in overloaded electrical
circuit, circuit breaker trips, or electrical hazard. Never use more than one BedJet on the same AC
circuit without Low Power switch ON.
Revision 1.0
MODEL SKU: VET‐800NA
ON/OFF Switch
Low Power Switch for setups with
two BedJets operating on same
AC circuit. SEE SAFETY DETAILS
BELOW.
Status Display Ring
Expansion Port for factory testing,
not a functional USB port
P a g e | 6