Bunn Silver Serie Guide D'installation Et D'utilisation page 9

Table des Matières

Publicité

OPERATING CONTROLS (Continued)
Product Dispense Switch (Membrane Switch Machines)
A. Product Dispense Switch
Momentarily pressing and releasing one of the switches will initiate a timed dispense. Each station has three
different timed dispenses which are preset at the factory. Refer to DISPENSER USE section for preset volumes
and adjustment procedures.
B. Plus/Stop Switch
This switch can be used to "top-off" a beverage. Pressing and holding switch will initiate product flow from
the respective nozzle; releasing the switch will stop the flow. Momentarily pressing this switch during a timed
dispense will stop the flow.
C. Chilled Water Dispense Switch (Optional for JDF-4S only)
Pressing and holding switch will initiate chilled water flow from the nozzle; releasing the switch will stop flow.
FIG 11 Product Dispense Switches - JDF-2S
Dispense Lockout Switch (JDF-2S shown)
This switch is located at the bottom front of the dispenser
just behind the drip tray. It is used to turn ON and
OFF the Dispensing function. It is also used for some
programming and fill procedures.
FIG 14 Program Switch
FIG 12 Product Dispense Switches - JDF-4S
FIG 13 Dispense Lockout Switch
Program Switch (JDF-2S shown)
This switch is located near the main control board next
to the refrigeration switch.
9
44744.2 062912

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jdf-2sJdf-4s

Table des Matières