Table des Matières
Publicité
TROUBLESHOOTING (cont.)
PROBLEM
Water leak filling drip tray or around
dispense deck area
Water leaking beneath machine
Erratic spray during dispense
Dispense nozzle dripping water
PROBABLE CAUSE
1. Initial fill/setup
2. Dispense deck
3. Water pressure greater than
100psi
1. Bath tank overflow.
2. Condensation from cabinet
cooling coil.
Dispense nozzle mixer missing or
broken
Dispense solenoid.
24
REMEDY
Some expansion normal. May fill
drip tray during initial ice block
formation
Inspect or replace fittings clamps,
o-rings, solenoids and quick
disconnect fittings.
NOTE: Dispense deck area slopes to
drain tube that leads to the drip tray.
Install water pressure regulator and
reduce to 50 psi.
A) Check all internal water
connections.
B) Check internal plumbing
connections.
Check for routing of condensation
tube to water bath.
Replace mixer.
Replace dispense deck solenoid.
44744.2 062912
Publicité
Table des Matières
