Lighting Instructions - COZY VC201C Consignes D'installation Et D'utilisation

WARNING:
If you do not
follow these
instructions
exactly, a fire
or explosion
may result
causing
property
damage,
personal
injury or loss
of life.
1. STOP! Read the information on the safety label.
2.
Turn temperature control knob to "OFF" or to it's lowest
position.
3. Depress and turn gas control knob clockwise
"OFF" position.
PILOT ADJ
NOTE: Knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not force.
4. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor. If you
smell gas, STOP! Follow "B" in the information on the
safety label. If you don't smell gas, go to the next step.
5. Open casing door and pilot lighting hole cover.
6. Find pilot. (Follow metal pilot tube from gas control).
7.
Locate red piezo ignitor button on top of heater.
8. Turn gas control knob counterclockwise
to "PILOT".
1.
Turn the temperature control knob to it's
lowest setting.
1017755-B

LIGHTING INSTRUCTIONS

MODELS:
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell
next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• DO NOT try to light any appliance.
• DO NOT touch any electric switch;
DO NOT use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
LIGHTING INSTRUCTIONS
Gas Control Knob
TURNING OFF GAS TO APPLIANCE
VC201C / VC351C
C. Use only your hand to push in or turn
D. Do not use this appliance if any part has
to
9. Push in gas control knob and hold in. Immediately begin
a series of pushing and releasing the red piezo ignitor
button, while observing the pilot. Continue to spark until
pilot is lit. Continue to hold the gas control knob in for
about one (1) minute after the pilot is lit. Release the gas
control knob and it will pop back up. Pilot should remain
lit. If pilot goes out, repeat steps 3 thru 9.
• If knob does not pop up when released, STOP &
immediately call your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas
control knob to "OFF" & call your service technician or
gas supplier.
10. Close pilot lighting hole cover and casing door.
11. Turn gas control knob counterclockwise
12. Turn temperature control knob to desired setting.
2.
Push in gas control knob slightly and turn clockwise
Page 10
/ VC501C
• If you cannot reach your gas supplier,
call the fire department.
the gas control knob. Never use tools. If
the knob will not push in or turn by hand,
don't try to repair it, call a qualified service
technician. Force or attempted repair may
result in a fire or explosion.
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
to "OFF". Do not force.
Pilot is
located on
the end of the
combustion
chamber
above burner.
to "ON".