Thermador PD304 Manuel D'utilisation Et D'entretien page 22

Section Four: USING THE COOKTOP
Disassembly/Assembly of the Grill
CAUTION:
• Use extreme care when placing the grill
components into the grill compartment.
Avoid contacting the ceramic igniter which
could break preventing operation of the
grill.
• The grill must be assembled as shown. The
drip tray heat shields must be in place, and
the burner must be properly positioned
relative to the gas supply.
assembly of the grill may result in unsafe
or hazardous conditions during operation.
• The grill radiant must be in place for proper
operation of the grill.
• Do not leave the grill unattended while in
use.
• Do not use charcoal briquettes or coals of
any kind.
Drip Pan
Incorrect
Exploded Views and Side View of Grill
Grill
Grate
Stainless
Steel Radiant
U-shaped
burner
Heat
Deflector
Grill Box
20
Follow the steps below to disassemble the
components in the grill box.
A. Remove the grill grate, stainless steel radiant and
burner from the grill box.
B. Remove the heat deflector from the slots on the
front panel of the grill box.
C. Remove the rectangular drip pan inside the grill
box as shown below.
Re-assembly
A. Replace the drip pan and heat deflector.
B. Insert the end of the burner into the slots at the
back of the grill box. Insert the tab on front of the
burner into slot in the heat deflector.
C. The stainless steel radiant lies on two (2) studs
on each end of the grill can.
D. Place the grill grate, with raised food contain-
ment rail oriented towards the grill box rear.
Burner placement in slots in back of grill