Getting Started - auna IR-190 Mode D'emploi

GETTING STARTED

Plug the adaptor into the DC in socket (on the rear of the product) and
switch the "ON/OFF" switch to "ON", then "Welcome" will be shown on the
screen.
Network Settings
After being plugged in, the radio will scan the available access point
automatically. You can use the button Navigator to choose the internet, and
then press OK to confirm the Internet. The steps are as below for first use:
1 There will be prompt: Would you like to configure Network now?
Press Navigator knob to Choose YES. Then the internet radio will scan
available network.
2 Choose the network you want to connect by switching the navigator
knob and press it to confirm.
3 It will remind you to enter password, by switching the navigator button
to input the number, letter or character. After finishing input, press
navigator knob to confirm your input.
4 Then your internet radio connected to your network.
Note: Below characters are available for the radio:
• Numbers (from 0-9)
• English letters (from A to Z and from a to z)
• Other characters (DEL,@,Blank,!,",#,$,%,&,*,',+ and (,)
EN
33