Risk Of Electric Shock - Liberty Pumps XLE100 Serie Manuel D'installation

Pump Wiring Instructions:

Always disconnect the pump from its power source before handling.

All electrical connections must be wired and grounded in accordance with the National Electrical Code and all
applicable local codes and ordinances.

Risk of electrical shock – Do not remove the power supply cord. All repairs and service must be performed by a
repair facility approved by Liberty Pumps and certified to work on explosion proof motor enclosures.

If power or control cord are damaged, or in need of replacement, contact Liberty Pumps for closest approved repair
facility.

All installations of pumps, controls, protection devices and general wiring should be done by a qualified licensed
electrician. All electrical and safety codes should be followed for the National Electrical Code (NEC), the
Occupational Safety and Health Administration (OSHA) and applicable local codes.
XLE-SERIES PUMPS
SINGLE PHASE (1 PH)
NOTE: The white and red leads of the
control cord are not used when wiring
single phase pumps.
For hazardous locations the control panel must be installed outside the hazardous area. Only approved controls that
have intrinsically safe float switch connections may be used for XLE-Series pumps. The control and power cables
cannot be spliced; a junction box may be used providing it is rated for hazardous locations and has approved cord
connectors.
WARNING

RISK OF ELECTRIC SHOCK

electrically live parts, items, fluid, or water can cause serious in-
jury or death.
©Copyright 2017 Liberty Pumps Inc. All rights reserved.
- Accidental contact with
XLE-SERIES PUMPS
THREE PHASE (3 PH)