Safety Information; Risk Of Electric Shock - Liberty Pumps 251-3 Manuel D'installation

1. Safety Information

DANGER
WARNING
CAUTION
NOTICE

ALWAYS disconnect the supplied pump(s) from their power sources before handling or making any adjustments to
either the pump(s), the pump system, or the control panel.

Only qualified personnel should complete fixed wiring and electrical connections, according to all local and national
electrical codes, during a pump system installation.

After installation, be certain that the pump is properly grounded, using its supplied grounding conductor. Failure to
properly ground the pump system can cause all metal portions of the pump and its surroundings to become ener-
gized.

During flood conditions, submerged electrical connections can energize the water. Always wear dielectric rubber
boots and other applicable Personal Protective Equipment (PPE) when water is on the floor and you must service an
energized pump system. DO NOT ENTER THE WATER if the water level is higher than that of the protection your
PPE offers or if your PPE is not watertight.

NEVER lift or carry a pump or a float assembly by its power cord. This will damage the power cord, and could ex-
pose the electrically live wires inside the power cord.

DO NOT bypass grounding wires.

The electrical power supply shall be located within the length limitations of the pump power cord, and for below
grade installations it shall be at least 1.22 m (4 ft) above the floor level.

NEVER use this product in applications where human contact with the pumped fluid is common (such as swimming
pools, fountains, marine areas, etc.).
This safety alert symbol in your manual and on the pump is intended to alert you
to a potential risk for injury or death.
This is a safety alert symbol identifying risk of electric shock. It will be accompa-
nied with an instruction intended to minimize your potential risk of electric shock.
This is a safety alert symbol identifying risk of fire. It will be accompanied with an
instruction intended to minimize your potential risk of fire.
This is a safety alert symbol identifying risk of injury or death. It will be accompa-
nied with an instruction intended to minimize your potential risk of injury or death.
Warns of hazards that will cause serious injury or death.
Warns of hazards that can or will cause minor or moderate injury.
Warns of hazards that can cause personal injury, death, or property damage.
Signals an important instruction related to the pump. Failure to follow these in-
structions could result in pump component failure, or improper operation of the
unit, possibly resulting in property damage .
WARNING

RISK OF ELECTRIC SHOCK

electrically live parts, items, fluid, or water can cause serious in-
jury or death.
©Copyright 2018 Liberty Pumps Inc. All rights reserved
- Accidental contact with
2