General Information And Safety Guidelines; Installation - Liberty Pumps CSP-237 Manuel D'installation

1. General Information and Safety Guidelines

Before installation, read the following instructions carefully.
performance. Closely following these instructions will eliminate potential operating problems, assuring years of trouble-free service.

Risk of electric shock. Always disconnect the pump from the power source before handling or making adjustments.

The electrical connections and wiring for a pump installation should only be made by qualified personnel.

This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric shock, be
certain that it is connected only to a properly grounded, grounding-type receptacle.

Do not bypass grounding wires or remove ground prong from attachment plugs.

Do not use an extension cord.

This pump requires a separate, properly fused and grounded branch circuit. Make sure the power source is properly sized for the
voltage and amperage requirements of the pump, as noted on the nameplate.

The electrical outlet shall be within the length limitations of the pump power cord, and at least 4 feet above floor level to minimize
possible hazards from flood conditions.

The installation must be in accordance with the National Electric Code and Plumbing Codes as well as all applicable local codes
and ordinances.

2. Installation

Fig. 1 – Typical Residential Installation
This is a recommended installation only.
Each Liberty pump is individually factory tested to insure proper
Figure 1
©Copyright 2011 Liberty Pumps Inc. All rights reserved -2-