Listo LVC 49L2B Notice D'utilisation page 38

If the pressure is lower than the minimum, seek advice from a qualified technician. If
the pressure is too high, please install a pressure reducer.
C
onneCtIon to the draIn
Insert the drain hose into a drain pipe with a minimum diameter of 40 mm (B) or let
•
the water run into the U-bend under the sink (A), making sure that the hose is not
bent or jammed.
Attach the drain hose to point A or B:
•
The free end of the
•
hose must be placed
at a maximum height
of 750 mm from the
surface on which the
dishwasher is installed
(worktop or floor) and
must not be immersed
in water.
This "free-standing" dishwasher is not designed to be built into a cabinet; it is
•
intended to be placed on the floor or on a work surface.
V.1.0
Connect the cold-water supply hose to a threaded
•
connector and check that it is properly tightened.
If the appliance is connected to new or unused pipes, let
•
the water run for a few minutes before connecting the
water supply hose. This will prevent sand or rust deposits
from clogging the filter at the water supply hose inlet.
Make sure that the water supply hose is not crushed or
•
bent.
( )
emptyIng
Front
Drain hose
B
38
surface
A
U-bend
φ 40mm
Work