Connect Power Cord - HP LaserJet 9000 Mode D'emploi

Step 9

Connect power cord

This section describes how to connect the power cord. HP
recommends connecting the power cord to a surge protector.
1
2
3
4
ENWW
To connect the power cord
1 Locate the power switch on the front
of the printer. Make sure the printer
is turned off (out position).
Note
If the printer is located on top of the
2,000-sheet feeder, do not connect the
printer power cord to the convenience
receptacle on this device. This connector
is designed to connect to the paper
output devices with the HP LaserJet
9000 series.
2 Connect the power cord to the
printer, a grounded power strip, or an
AC outlet.
3 Press the power switch to turn the
printer on (in position). After the
printer warms up, the READY
message should appear on the
control panel display.
4 If you have the optional 3,000-sheet
stapler/stacker (or stacker), optional
Tray 4, or both installed, check that
the light on them is solid green. If the
light is amber, flashing, or off, see
the HP LaserJet 9000 Use manual
(supplemental user guide) that can
be downloaded from
www.hp.com/support/lj9000.
Connect power cord 19