Connecting The Magnification Feature Pack To The Optelec Clearreader; Magnification Views; Page View - Optelec ClearReader+ Manuel D'utilisation

Optelec

Connecting the Magnification Feature Pack to the Optelec ClearReader

Connect the Magnification Feature Pack to the ClearReader
VGA connector at the bottom rear side of the ClearReader
you will need to remove the protection cover which will also reveal two USB connectors. Use a
Philips screwdriver to remove the screw which closes the cover. This screw is located in the
middle of the cover at the bottom side of the ClearReader
+
ClearReader by using a VGA cable. Adjacent to the VGA connector, there are two USB ports.
Connect the USB cable of the ClearReader
ports on the rear side or to the USB port on the right side of the unit.
When the Magnification Feature Pack is connected to the ClearReader
+
ClearReader and take a snapshot of a document as described in this manual.

Magnification views

With the ClearReader
different Views: Page view, Column view, Line view and as a full page Overview. To switch
between the different views, press the View button on the Magnification Feature Pack.

Page View

The Page view shows a photograph of the document in its original layout, including the pictures.
English
+
Magnification Feature Pack, you can view captured documents in four
+
and optionally, a monitor. Locate the
+
. If the VGA connector is not visible,
+
. Connect the monitor to the
+
Magnification Feature Pack to one of the two USB
ClearReader
+
+
, switch on the
Page 21
+