Dell Latitude C/Dock II Expansion Station Guide page 26

24
Sys t em In f or ma t i o n G u i d e
R e p l a c i n g t h e B a t t e r y
expansion-card
slots (2)
Slightly lift up the battery securing tab and remove the battery from
5
the battery socket.
Orient the new battery with the side labeled "+" facing up. Then
6
insert the battery into the socket and release the securing tab.
Do not dispose of this battery along with household waste. Contact your
local waste disposal agency for the address of the nearest battery deposit
site.
Removing and Installing a PCI
Expansion Card
To install a Peripheral Component Interconnect (PCI) expansion card in
the docking device, perform the following steps.
NOTE: Install 3.3-volt (V) or 5-V PCI expansion cards no longer than 10
inches (25.4 centimeters [cm]) in the top slot and install 3.3-V or 5-V PCI
expansion cards no longer than 6.9 inches (15.5 cm) in the bottom slot.
NOTICE: Do not touch or handle anything inside the docking device except
those objects mentioned in the following procedure. If you touch other objects,
you may damage the docking device, and may void your warranty.
battery
battery
socket
battery
securing
tab