Replacing The Battery - Dell Latitude C/Dock II Expansion Station Guide

Masquer les pouces Voir aussi pour Latitude C/Dock II Expansion Station:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

22
Sys t em In f or ma t i o n G u i d e
Press the undock request button on the docking control base (see the
figure "Docking Control Base Controls and Indicators"). Wait for the
green docking light to turn off.

Replacing the Battery

Your docking device uses a lithium ion battery. The lithium ion cell battery
is a long-life battery, and it is very possible that you will never need to
replace it. However, should you need to replace it, perform the following
steps.
CAUTION: There is a danger of a new battery exploding if it is
incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used
batteries according to the manufacturer's instructions.
Undock the computer as described in "Undocking the Computer."
1
Turn off the power switch on the docking device and disconnect the
2
AC adapter.
Remove the top cover by pressing the two side buttons and rotating
3
the cover toward the back of the expansion station (see "Removing the
Top Cover"). Once the cover is vertical, disengage the hinge tabs, and
fully remove the cover.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pdx

Table des Matières